V2000-c Rfid Access Control User Manual ((install))

💡 Presenting a card immediately after 11 or 13 is often easier than typing card number.

is a reliable, standalone single-door access controller designed to secure doors, gates, and commercial entry points . Operating primarily on a , this rugged device features an integrated contactless EM RFID reader and an illuminated keypad. It supports up to 2,000 distinct users , giving administrators the flexibility to grant access via proximity cards, custom PIN codes, or a combination of both.

If you need specific wiring diagrams, reset instructions, or advanced features (like anti-passback or time schedules), please provide the exact or brand label from your device.

Press * + Master Code + # (Example: * 9 9 9 9 # ) Exit Programming Mode: Press * Changing the Master Code V2000-c Rfid Access Control User Manual

A: Please follow the Initialization Procedure in Part IV. This will restore the password to 12345 .

The V2000-C allows you to assign specific User IDs (from 1 to 1000) to keep track of individual users or delete lost cards easily.

V2000-C Terminal Block ------------------------------------------------ +12V → Power supply positive GND → Power supply negative (common ground) NO → Normally open (to lock’s positive unlock wire) COM → Common (to lock’s negative / power supply GND) NC → Normally closed (rarely used with fail-secure locks) PUSH → Exit button (one side; other side to GND) SEN → Door contact sensor (to GND when door closed) ALARM → Optional alarm output BELL → Optional buzzer output 💡 Presenting a card immediately after 11 or

If you forget the Master Code, you can reset the device manually without erasing existing user cards: Power down the device.

Before powering on the device, you must double-check that the input voltage is exactly DC 12V and that the positive and negative polarity is correct. Reversing the polarity may cause irreversible damage to the system.

Sets the authentication method to require BOTH a valid card AND a valid PIN code for entry. It supports up to 2,000 distinct users ,

Fail-safe locks require continuous power to stay locked. Power drops to unlock. Connect Power Supply (+12V) to Keypad COM . Lock Connection: Connect Keypad NC to Lock (+).

If you’d like, I can:

You can configure how users authenticate themselves to gain entry. In programming mode, press 3 + 0 + # .