Powermta 60r3 Install ((exclusive))

The primary configuration logic resides within /etc/pmta/config . Open this file in your preferred text editor to structure your routing environment. nano /etc/pmta/config Use code with caution.

Use pmta sendmail or the HTTP injection API.

sudo systemctl start pmtahttp sudo systemctl enable pmtahttp Use code with caution. Copied to clipboard 6. Verification Check Status: pmta show status to see if the service is running. Web Console: Open your browser and go to powermta 60r3 install

If the installer did not prompt you, or if you need to update the license, use the pmta command to activate: pmta set-license "YOUR-LICENSE-KEY-HERE" Use code with caution. 4. Initial Configuration The main configuration file is located at /etc/pmta/config . Step 4.1: Edit the Configuration File Open the file using nano or vi : nano /etc/pmta/config Use code with caution. Step 4.2: Essential Configuration Settings

You've successfully installed PowerMTA 6.0r3 on your Linux server. By following the steps in this guide, you've moved past the initial hurdles and set up the core configuration, a web monitor, and learned how to troubleshoot common issues. Use pmta sendmail or the HTTP injection API

Ensure OpenSSL, PAM, and necessary libc packages are installed (usually present by default).

Verify your hostname by running hostname -f . It should output your new FQDN. Update System Packages Verification Check Status: pmta show status to see

The heart of the installation is /etc/pmta/config . You must define: : To access the web-based monitoring console. domain-macro : To set up your sending domains. virtual-mta : To map your IP addresses. Start the Service : Start the daemon and enable it on boot: systemctl start pmta systemctl enable pmta Use code with caution. Copied to clipboard Verify via Web Monitor :

: Configure which IPs are allowed to submit mail to the server. 4. Service Management