Gunnebo Speedstile Fl Installation Manual [upd] -

A minimum concrete depth of 150 mm is required to anchor the structural bolts securely. Tolerance: Floor deviation must not exceed ±plus or minus 2 mm across the entire footprint of the speed gate lane. Environmental Conditions

Use a laser level or string line to ensure all cabinets are perfectly parallel and aligned along the front edge. Misalignment will cause optical sensor faults. 4. Mechanical Anchoring and Leveling

Do not lift the pedestal by the glass barrier or the top cover. Use the designated lifting handles on the steel chassis. gunnebo speedstile fl installation manual

1200 mm or 1400 mm (depending on model variant). Cabinet Height: 1020 mm (standard glass height varies). 2. Site Preparation and Flooring Requirements

conduit connecting the Master (M) cabinet to the Slave (S) cabinet for the synchronisation cable. 2. Unboxing and Component Checklist A minimum concrete depth of 150 mm is

, thorough preparation is required to prevent delays and structural issues.

All access control integration interfaces with the main controller board inside the master cabinet. Terminal Label Connection Type Open Direction A Dry Contact (Normally Open) IN2 / open B Open Direction B Dry Contact (Normally Open) GND Common Ground Reference Ground FIRE Emergency Fire Drop Dry Contact (Normally Closed) SYS_OK Turnstile Status Output Relay Output (NO/NC) Misalignment will cause optical sensor faults

Ensure the panels are aligned to avoid collision during operation. Step 5: Safety Sensor Alignment SpeedStile FL

Check the alignment: when closed, the wings must align perfectly in the center of the lane with an equal gap on both sides (typically 10 mm to 15 mm between panels).

Plug the heavy-duty data connectors into the designated ports on the respective control boards. Secure the cable using internal strain-relief clamps. Peripheral and Access Control Integration