Double Stringer Staircase Detail Dwg Free !full! -
Click the link below to download the free DWG file:
The connection of the stringer to the foundation or ground slab. 3. Detail Views (Zoomed-in Connections) These are critical for fabricators.
An architectural or shop drawing for a double stringer system must include precise dimensions and annotations to be functional. Ensure your DWG file accounts for the following parameters: Material Standards (Steel Example) Commonly Rectangular Hollow Sections (RHS), or thick laser-cut plate steel. Tread Support Cleats: Typically thick steel plates welded directly to the stringer profile. double stringer staircase detail dwg free
Disclaimer: Free CAD details should always be reviewed and verified by a licensed structural engineer prior to construction or fabrication to ensure compliance with local building regulations and load-bearing requirements.
Ensure the drawing is in the correct units (Metric or Imperial) before importing. Click the link below to download the free
Steel or wooden treads typically require thick mounting plates (usually steel tabs) welded directly to the stringer. 2. Standard Code Requirements (IBC & OSHA) Riser Height: Max ) per riser for residential/commercial (IBC). Tread Depth: Min ) to ensure adequate footing.
: A standard "comfortable" stair typically has a rise of 7 to 7.5 inches and a run (tread depth) of 10 to 11 inches . The "27 Rule" suggests the sum of one riser and one tread should equal approximately 27 inches for optimal ergonomics . An architectural or shop drawing for a double
| Parameter | Typical Requirement | | :--- | :--- | | | Minimum 36 inches clear | | Maximum Riser Height | 7.75 inches (197 mm) / 7 inches (NADRA/IRC) | | Minimum Tread Depth | 10 inches (254 mm) / 11 inches (NADRA/IRC) | | Guardrail Height | Minimum 36 inches (measured from tread nosing) | | Baluster Spacing | Must prevent passage of a 4-inch sphere |
A is more than just a drawing—it’s a roadmap to a safe, beautiful, and code-compliant staircase. By downloading from reputable sources like CADdetails, Bibliocad, or First In Architecture, and then customizing the detail to your specific rise, run, and material choices, you eliminate guesswork and reduce material waste.
For two stringers without center support, stay within 36 inches . Wider stairs often require a third stringer or heavier structural members.
This is the distance from the ground (or lower floor) to the finished floor level of the landing or upper floor.