C3560-ipservicesk9-mz.150-2.se11.bin =link= Jun 2026

While the lower-tier "IP Base" image supports basic static routing and RIP, IP Services introduces full dynamic enterprise routing protocols:

Switch(config)# boot system flash:C3560-ipservicesk9-mz.150-2.se11.bin Switch(config)# end Switch# write memory Use code with caution. Step 6: Reload and Verify

: The switch must have at least 32 MB of flash memory. The binary file itself typically occupies roughly 15 to 20 MB, leaving little room on older 16 MB models. C3560-ipservicesk9-mz.150-2.se11.bin

: The target hardware platform. This image runs exclusively on standard 32-bit hardware architectures of the Catalyst 3560 family (e.g., WS-C3560G-24TS, WS-C3560V2-48PS). Note: It is not built for the newer 3560-X or 3560-E lines, which use different architectures.

You will need a server application (like SolarWinds TFTP, TFTPD64, or Packet Tracer) running on your PC to host the .bin file. While the lower-tier "IP Base" image supports basic

: Enables full-featured EIGRP topology tables and stub routing.

Once the file is verified in flash, you must tell the switch to boot using this new image the next time it reloads. : The target hardware platform

This translates to . The “SE” denotes Service Provider or Switch Enterprise train. The .se11 indicates the 11th maintenance rebuild of 15.0(2). This is a mature, highly stable release – the final build in the 15.0(2)SE family.

Indicates the image runs in memory (m) and is compressed (z).