Remove the BLACK (Negative -) clip first, followed by the RED (Positive +) clip. 4. Troubleshooting and Maintenance
The is a reliable, compact, and efficient charging solution designed for 12V lead-acid batteries. Often utilized for cars, motorcycles, and small marine applications, this 4-amp charger provides a straightforward approach to battery maintenance.
Before operating the unit, familiarize yourself with its electrical limits and capabilities: 220V–240V AC, 50/60 Hz Output Voltage: 12V / 24V DC (Selectable) Normal Charge Current: 30A Maximum Charge Current: 50A Boost/Start Current: 250A–300A (Peak) Compatible Battery Capacity: 20Ah–600Ah Battery Types: Lead-acid, AGM, GEL, and Wet cell 2. Important Safety Precautions
(Read this section before use to prevent injury or damage.) bradex bx60 battery charger manual full
Understanding the limitations and capabilities of your Bradex BX60 ensures safe and optimal performance. 220V - 240V AC, 50Hz Output Voltage: Dual compatibility (6V and 12V modes)
The Bradex BX60 is a "set and forget" charger. Here is what happens internally after you plug it in:
Arthur folded the manual, put it in his shirt pocket, and unclipped the BX60. The needle fell to zero. The humming stopped. The garage was silent. Remove the BLACK (Negative -) clip first, followed
Operating Instructions: Engine Start Boosting (Jump Starting)
A: With an output of 4 amps, charging times can vary significantly based on the battery’s capacity and starting condition. A typical 50Ah battery that is half discharged would take approximately 6–7 hours to reach a full charge.
Never connect or disconnect the DC output clamps while the AC power cord is plugged into the wall. Often utilized for cars, motorcycles, and small marine
: Once the needle remains constant at its lowest point, switch off the mains and unplug the charger before removing the clamps to prevent sparks. ⚠️ Essential Safety & Maintenance
Clean battery terminals before connecting the charger. Avoid getting corrosion in your eyes.
Always make connections before turning the main power switch ON.